J&M Products Subframe Connectors Full Length (1979-2004 Ford Mustang)

$79.99
SKU
JM-25107
Helps reduce chassis flex and improves handling
Our layaway program allows you to make payments whenever you can. Once you pay off your layaway purchase, we will ship your new products to you.

1979-2004 Ford Mustang Subframe Connectors Full Length.
This is the first thing that should be done on uni-body vehicles, even if you do not plan to increase the performance of the engine, is the installation of subframe connectors! Connectors assist in maintaining the integrity of the vehicle. Take a close look at any unibody car that has been run hard. The doors don’t close quite right and the alignment shop has trouble getting the car to drive straight.

If you want your car to remain rattle free and you want to get the most out of other chassis and engine mods, you have to connect the front and rear frame sections with something stronger than sheet metal. Sub-frame connectors are an absolute requirement for all types of driving.

Features and Benefits:
-Taller than most at 1.50″ to increase the strength over our competition who typically use 1.00″ tall tubing
-Longest full length on the market at 66 inches long for increased weld area
-Fits 1979 through 2004 Mustangs
-A necessity for any performance minded builder
-Stops power robbing chassis flex
-Improves responsiveness and control
-Shaped to hug the floor pan of your vehicle for maximum ground clearance
-Doubles as a jacking rail
-Capped ends to seal ends from debris and water
-Optional black powder coat to prevent corrosion
-Weld-in design is far superior and stronger than bolt-in styles

More Information
Condition New
Warranty 1 Year
Manufacturer J&M Products
Manufacturer Part No 25107
Write Your Own Review
You're reviewing:J&M Products Subframe Connectors Full Length (1979-2004 Ford Mustang)