AMT Motorsports Brey-Krause Harness Bar (C7 Corvette)

The Brey Krause Model R-1125 Harness Bar for the C7 Corvette properly locates and supports racing shoulder harnesses relative to the driver. In the case of an accident, it helps protect the driver's shoulders and spine. The harness guides also prevent excessive shifting and fatigue of the driver during the high G loads of cornering and braking. BK bars are easy to install and remove, and will get you ready for the track in just a few hours!

Note: Because of mounting locations in the C7, the B-Pillar plastic sail panel covers will require slot on either side to be cut. Sail panels replacements can be ordered from your GM Dealer if you do not want to cut the original panels (Part 23176134 for driver side, and part 23176135 for passenger side). Strength requirements for harness mounts are considerably greater than those for harness guide bars since they must support the entire load applied to the belts. 

• Material: Type 304, stainless steel
• Finish: Powdercoated in durable black wrinkle-finish
• Weight: 17.12 lbs.
• Installation: Bar attaches to factory mounting points in "B" pillars.
• C7 Coupes and Z06 Coupes