BMR Suspensions Sway Bar Kit, Front, Hollow 38mm, 4-hole Adjustable (15-23 Mustang)

The two primary functions of sway bars are to control body roll and to determine the understeer or oversteer behavior of a vehicle. Stock sway bars have low torsional spring rates because they are manufactured from small diameter bar stock or tubing. BMR Suspensions SB764 front sway bar kit was designed by factoring in the vehicle weight, application, motion ratio, coil spring rate, and adjustability requirements. Manufactured from heavy-duty 38mm DOM steel tubing, the SB764 is cold formed to better resist torsional fatigue and retain its "memory" far longer than the hot-formed bars used by many competitors. The sway bar is CNC-formed for exact manufacturing tolerances and repeatable high quality. Thrust washers are welded to the bar to locate the sway bar bushing mounts. This is critical as it properly locates the sway bar and prevents lateral movement during hard cornering maneuvers The SB764 attaches to your S550 Mustang with polyurethane bushings, reducing the deflection from the stock rubber bushings. These bushings are molded from 88-durometer, low-deflection, polyurethane, and are internally fluted to keep grease in the bushing.

BMR Suspension designed the SB764 sway bar kit for street performance, autocross, and road race applications. The adjustable sway bars four positions give you the versatility to drive to and from the road course or autocross and still out handle the competition with the same sway bar. The SB764 gives you a 58%-157% increase in sway bar rate over the stock bar. The adjustability and rate increases allow you to fine-tune the handling characteristics of your S550 Mustang so you can drive harder through corners with minimal body roll. The hollow design allows for loads of strength in the lightest package possible. This means increased performance with no sacrifices. The SB764 attaches to your Mustang with 88-durometer polyurethane bushings, reducing the deflection from the stock rubber bushings, allowing for more sway bar control, equaling better handling. When performance is a must, rely on BMR Suspension!

BMR Suspensions SB764 sway bar kit is available in black hammertone and red powdercoat for long-lasting good looks. Installation time is about 1-2 hours. Proudly made in the U.S.A.!