Chevrolet Performance 454 HO 454ci Crate Engine 438 HP @ 5,300 RPM

$9,525.00
SKU
19433409
Our layaway program allows you to make payments whenever you can. Once you pay off your layaway purchase, we will ship your new products to you.

454 HO 454ci Engine

INSTALLATION NOTES:

  • Requires addition of carburetor, starter, fuel pump, distributor and ignition system (not included)
  • Clutch linkage bosses are now drilled and tapped. When using cast-iron exhaust manifolds, lower head bolts may need to be replaced with bolts with shorter heads, for clearance
  • Comes with an externally balanced 14'' automatic transmission flexplate; use flywheel P/N 809-14096987 and 11'' clutch assembly for manual transmission applications
  • Designed for pre-1976 street vehicles or any off-road vehicle
  • Not intended for marine applications
  • Motor equipped with truck style oil pan and pickup. Vehicle specific oil pan and pickup required for installation.

Engine Break-In Procedure

Use conventional or break-in oil (non-synthetic) for the first oil change, be sure to check the oil level in the engine and prime the oil system with an engine priming tool. 

Engines with flat tappet hydraulic cams only - Run the engine between 2,000 and 2,500 RPM's, with no-load on the engine for the first 30 minutes. This is critical to break in the camshaft.

Drive the vehicle with varying speeds and loads on the engine for the first 30 miles. Be sure not to use a lot of throttle or high RPM.  Run five or six medium-throttle accelerations to about 3000 RPM (40 to 50 MPH), then letting off in gear and coasting back down to 20 MPH. Run a couple of hard throttle accelerations up to about 5000 RPM (55 to 60 MPH), then letting off in gear and coasting back down to 20 MPH.

Let the engine cool and change the oil and filter using conventional (non-synthetic) oil and check coolant level, top off if necessary. Drive the next 500 miles normally, without high RPM's (below 5000 RPM), hard use, or extended periods of high loading.  Change the oil and oil filter again using conventional (non-synthetic) oil.  Keep an eye on oil level during the first thousand or so miles.

It would be suitable to use synthetic motor oil after the second recommended oil change and mileage accumulation.

19433409 supersedes 12568774

Specifications:

Part Type
Engine Block Material
Cast iron
Cylinder Head Material
Cast iron
Engine Make/Size
Chevy Big Block
Engine Assembly Style
Long block
Engine Balance
External
Assembled
Yes
RPM Power Range
1750-5250
Horsepower
438
Compression Ratio
8.75:1
Cylinder Heads Included
Yes
Camshaft Style
Hydraulic roller tappet
Intake Manifold Included
Yes
Carburetor Included
No
Throttle Body Included
No
Distributor Included
No
Oil Pan Included
Yes
Timing Cover Included
Yes
Water Pump Included
Yes
Harmonic Balancer Included
Yes
Valve Covers Included
Yes
Flexplate Included
No
Flywheel Included
No
Air Cleaner Included
No
Spark Plugs Included
No
Spark Plug Wires Included
No
Fuel Delivery
One Carb
Computer Included
No
Wiring Harness Included
No
Rear Main Seal Style
1-piece
Quantity
Sold individually
Engine Displacement
454 ci.
Engine Type
High-Performance Crate Engine
Shipping Weight:
735
More Information
Manufacturer Chevrolet Performance
Manufacturer Part No 19433409
Write Your Own Review
You're reviewing:Chevrolet Performance 454 HO 454ci Crate Engine 438 HP @ 5,300 RPM