Installation Notes:
- For use with 8L90-E transmission
- Engines shipped with high-pressure direct-injection fuel pump installed
- Assembly does not include electronics
- Use LT1 Controller for engine operation. Kit includes an electronic throttle pedal, which is required for throttle input to the ECU.
- Intended for pre-1976 street vehicles or any off-road vehicle
- Not intended for marine applications
- 8-bolt crankshaft flange
- Shipped with 14'' flexplate
Engine Break-In Procedure
Use only engine oil that meets dexos1 specifications. For track events or competitive driving, use Mobil 1 15W-50 engine oil. Fill the engine with oil and follow the proper engine priming procedure. Also check and fill as required any other necessary fluids such as coolant, power steering fluid, etc.
Start the engine and listen for any unusual noises. If no unusual noises are noted, run the engine at approximately 1,000 RPM until normal operating temperature is reached. The engine should be driven at varying loads and conditions for the first 30 miles or one hour without wide open throttle (WOT) or sustained high RPM accelerations. Run five or six medium throttle (50%) accelerations to about 4,000 RPM and back to idle (0% throttle) in gear. Run two or three hard throttle (WOT 100%) accelerations to about 4,000 RPM and back to idle (0% throttle) in gear.
Change the engine oil and filter. Inspect the oil and the oil filter for any foreign particles to ensure that the engine is functioning properly. Drive the next 500 miles (12 to 15 engine hours) under normal conditions. Do not run the engine at its maximum rated engine speed. Also, do not expose the engine to extended periods of high load. Change the oil and filter again, and inspect the oil and oil filter for any foreign particles to ensure that the engine is functioning properly.
19431953 supersedes 19418843
STAY CONNECTED
Sign up to be the first to hear about us